I'm a bit stumped with the function generator on this unit. I'm trying to calibrate a selfmade series 500 microphone preamp (it works – just needs final gain and distortion calibration), but for some reason I'm not able to output a standard sinewave 1kHz signal using the aux output and a bnc to xlr cable… what am I doing wrong? I've crimped the bnc connector to one end (red/signal to center pin, ground to crimp barrel) , soldered a male xlr plug to the other and bridged pin 2 (red/signal) & 3 (white/inverted signal) while having my ground connected to pin 1. No matter what I try, I can not get a reading in my daw. Maybe someone can give me an idea of what I am missing here.

price performance is very poor

zOOm!

It's easy to set up

Question, is the filter setting something like a software defined band pass filter ? because that would be kind of cool; though I can't think of a use for it but it sounds cool XD

RIGOL have better parameters and cheaper.

Hello. Please help in choosing between:
OWON XDS3104AET
Rohde & Schwarz RTC1002 MAX
Rigol MSO5074

get a room…jeez

Which camera did you use to make this video? Close shooting of PCBs is brilliant

Hi Dave, just took a look at this, I see the "HM" infront of the model number, following HAMAG tradition, I know R&S took over HAMEG for sure this unit is VERY tidy inside & designed very well :), impressive unit, cost is humm a little high in price I personally feel, knowing how cheap the early "HAMEG range" was when it was HAMEG. but I guess now its R&S, the only thing I hate to see is a battery on a PCB, leakage can cause big problems as we all know, perhaps a buffer to the FPGA from the outside world might have been better protection for the FPGA ?, only personal preference would have liked to see nuts on the BNC to prevent less movement on the PCB joints,

Line triggering generator board won my heart

You can't fault German engineering.

Yolo, engineering research video.
+Engineering_team.